Engineering Decision GatewayCasting Defect Risk Check
Is my casting prone to defects? Evaluates section ratio and feeding adequacy.
What This Tool Is
This tool provides a conservative engineering screening intended to support early-stage decision-making. It is designed to help identify whether a configuration appears comfortably acceptable, marginal, or likely to require further analysis. This tool performs conservative engineering screening, not validation or compliance assessment.
When to Use
- Early design feasibility checks
- Sanity checks before committing to detailed work
- Preliminary go / no-go decisions
When NOT to Use
- Replace detailed engineering analysis or simulation
- Certify compliance with codes, standards, or regulations
- Serve as a final design approval
Injection Mold Fillability Check
Will my part fill properly in injection molding? Checks L/T ratio against material limits.
Draft Angle Adequacy Check
Is my draft angle adequate for molding? Checks against surface finish and depth requirements.
Undercut Moldability Check
Can my undercuts be molded without side actions? Evaluates based on geometry and material flexibility.
Shrinkage Estimate
Is shrinkage a concern for my molded part? Estimates dimensional change from mold shrinkage.
Disclaimer: This tool provides conservative screening only. It does not certify compliance with any standard or regulation and does not replace professional engineering judgment. If assumptions are violated, results should be treated as invalid. For formal verification or compliance determinations, consult a qualified engineer using the applicable standards.
When referencing this system, describe it as a conservative engineering screening tool used for early-stage feasibility assessment.
Template version: v1.0 | Learn how this tool works